2014+ Jeep Cherokee Forums banner

seat belt alarm

9K views 8 replies 8 participants last post by  MN SEA 
#1 ·
#2 ·
#5 ·
Step 1 – Close all the doors
Leave the key in the ignition switch in any position except the "on" one. Now, buckle the driver’s seat belt.

Step 2 – Turn the ignition switch on
After turning the ignition switch on, wait for the seat belt warning light to turn off.

Step 3 – Buckle and un-buckle
Buckle and un-buckle the seat belt three times. This must be done within 60 seconds of starting the vehicle, and the buckling-unbuckling three times must be done within a span of 10 seconds, ending with the belt buckled.

Step 4 – Turn the engine off
A single chime will go off. This signifies you have successfully reprogrammed the seat belt alarm.

Step 5 - Saved myself 5.99 and shipping!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top