2014+ Jeep Cherokee Forums - Conversation Between David_Baker and MrLimited
Conversation Between David_Baker and MrLimited
Showing Visitor Messages 1 to 2 of 2
  1. David_Baker
    01-06-2016 05:26 AM - permalink
    Hey mate, apologies I missed the message!

    not sure if I have already answered so will answer again just in case! The bracket was made from a strip of 50mm with x 3mm thick galvanised steel (picked up from the local hardware store). Bent at 90 and another peice welded across the front that runs under the number plate. Drilled two holes to match the number plate hole and the screws go through the plate, the bracket and then into the bumper. The top has two bolts locked to the strip with nuts, the bolts then run through the plastic at the top/back of the bumper then into the metal underneath. They have a nut either side of the metal making the height adjustable.

  2. MrLimited
    12-29-2015 09:25 AM - permalink
    Hi David,

    Just curious if you could shed some light on your lightbar. I would like to install the same on my Limited. Is it possible?